Popular Articles
Adding Ruled Surface Constraint Lines
Adding Ruled Surface Constraint Lines When working with a 4 axis program, the upper and lower nozzles may not synchronize properly. In cases like this you will need to manually tell the nozzles where to synchronize. Attached is a short video on how ...
Creating a Billet In Opticam Classic
Creating a Billet Attached in this article is a short video detailing how to create a simple rectangle billet. The Billet is a representation of the block you are cutting your part out of. You will need a billet to run your Standard Simulation in ...
Downloading and Installing Opticam for Solidworks
Downloading and Installing Opticam for Solidworks Below are the written instructions for downloading and installing the software. You can also view it online at Downloading and Installing Opticam for Solidworks 1) Choose your version required from ...
Working with Figures
Working with Figures in PEPS/Opticam Classic Working with figures is a core part of using PEPS/Opticam Classic effectively. This guide will walk you through the essential steps involved in figure creation and management: What This Guide Covers: How ...
Importing .kno files into V8.2
Importing .kno files into V8.2 Starting in Opticam Classic V8.2, you will need to import .kno files into a database. Attached is a video showing how to import the .kno files in V8.2. Alternatively, if you would like to revert back to the old style ...