Common Questions and Answers
Version of Nucleo is Not Licensed for Current Solid Cut Cad
If you receive this error message when trying use you newly installed software, it is because the Build you are using was installed in the wrong SolidCut Cad version. This most likely happens when you only install the update and not the newest ...
Bolt Hole Patterns Explained
Nucleo Bolt Hole Explanation Nucleo adds bolt holes starting from the center of the base plate and expanding out based on the Pitch entered for X and Y. The dead-zone parameter tells Nucleo what bolt holes it is allowed to keep on the edge of the ...
Debugging failed base-plate geometry (Nucleo)
Debugging failed base-plate geometry (Nucleo) Should the base-plate fail to create correctly, refer to the video attached for options to remedy/debug the matter. https://www.optisolutionsusa.com/kb/Base-plate-failure.mp4
Exploding Assemblies into parts for Nucleo and naming the VDM file automatically
Exploding Assemblies into parts for Nucleo and naming the VDM file automatically When using Nucleo, Solid Part assemblies must be exploded first. Here are some options: Method 1 (automatically upon import): 1) Start OPTICAM/Nucleo. 2) Go to ...
Nucleo QA Steps
Nucleo QA Steps 1) Run the "Check" option to look for interference and to identify any differing blade thicknesses. 2) Check if the number of tabbed feet is adequate? Are there too few or too many? Closer pitch or wider pitch? Are they deep enough? ...
Checking Nucleo's DXF Output - Creating IGES files in addition
Checking Nucleo's DXF Output - Creating IGES files in addition The files created for 2D cutting from Nucleo are normal DXF files - you can open them in SOLIDWORKS or this handly free DXF viewer: http://www.jetcam.com/free-cad-viewer.htm The DXFs out ...
Nucleo - Nucleo - Weld Table Reference Position
Nucleo - Nucleo - Weld Table Reference Position Please refer to this video for an explanation: https://youtu.be/o9mKIilFzn0