Nucleo - Nucleo - Weld Table Reference Position

• Related Articles

• Nucleo - Adding Edge Detail (additional material)

  Nucleo - Adding Edge Detail (additional material) ​When Nucleo offsets the part in the fixture, it offsets on all sides around the perimeter of the solids. You may want to add some material back in some rare instances, and this article explains how ...

• Nucleo Build Q2 2020 #123. Changes to algorithm

  Nucleo Build Q2 2020 #123. Changes to algorithm ​Recent improvements have been made to the core Nucleo algorithm that creates the underlying geometry for the blades. As of the time of publication (June 23rd 2020) this is in BETA for testing ...

• Nucleo QA Steps

  Nucleo QA Steps 1) Run the "Check" option to look for interference and to identify any differing blade thicknesses. 2) Check if the number of tabbed feet is adequate? Are there too few or too many? Closer pitch or wider pitch? Are they deep enough? ...

• Using pre-existing lines to denote Nucleo Fixture Blade positions

  Using pre-existing lines to denote Nucleo Fixture Blade positions ​Please refer to this video: https://www.youtube.com/watch?v=alBidNJMoq4&feature=youtu.be

• Debugging failed base-plate geometry (Nucleo)

  Debugging failed base-plate geometry (Nucleo) ​Should the base-plate fail to create correctly, refer to the video attached for options to remedy/debug the matter. https://www.optisolutionsusa.com/kb/Base-plate-failure.mp4