Creating Multiple Post Processor Profiles V8.2 and Prior

Creating Multiple Post Processor Profiles V8.2 and Prior

Creating Multiple Post Processor Profiles
​In the attached video, you can see how to create a second profile for a post. If you want to have a second profile for a different machine or just have different post processor settings.

    • Related Articles

    • Additional Wire Machine Post Profiles - TEXT

      With the introduction of Version 2022, you now have the possibility to install directly your machine profile, meaning you have multiple machines from the same Mfg. but different models. VIDEO VERSION CAN BE SEEN AT THE LINK BELOW Additional Wire ...

    • Installation and Set-Up of ACCut C/E/P Series and ACCut X00 Post Processors and EDM Expert

      Installation and Set-Up of ACCut C/E/P Series and ACCut X00 Post Processors and EDM Expert  Outline -------------------- - Installation and Set-Up of ACCut C/E/P Series and ACCut X00 Post Processors - Installation and Set-Up of EDM Expert  These ...

    • Opticam Classic Uniqua Post Settings

      Hello, With the new Uniqua post some settings will need to be set up to make sure that the post is working correctly. There are 2 Options to Post for that Machine. Dynamic or Sequential. For more information into what the differences are you will ...

    • Creating a Billet In Opticam Classic

      Creating a Billet ​Attached in this article is a short video detailing how to create a simple rectangle billet. The Billet is a representation of the block you are cutting your part out of. You will need a billet to run your Standard Simulation in ...

    • Transferring Saved System Default Settings and Technology Data V8.2 and Prior

      Transferring Saved System Default Settings and Technology Data NOTE: Because of changes to the way PEPS/OPTICAM CLASSIC works with Post Profiles now, the below method no longer works for V2022.  Please follow the new KB for that information. Outline ...