Adding Ruled Surface Constraint Lines

Adding Ruled Surface Constraint Lines

Adding Ruled Surface Constraint Lines
​When working with a 4 axis program, the upper and lower nozzles may not synchronize properly. In cases like this you will need to manually tell the nozzles where to synchronize. Attached is a short video on how to add constraint lines to help your nozzles synchronize in a 4 axis program.

    • Related Articles

    • How do I download and install PEPS Wire EDM software?

      This guide will walk you through downloading and installing the PEPS Wire EDM software. Make sure you have Administrator rights on your computer before you start. 1. Download the Software First, we need to get the installation files from the official ...

    • Additional Wire Machine Post Profiles - TEXT

      With the introduction of Version 2022, you now have the possibility to install directly your machine profile, meaning you have multiple machines from the same Mfg. but different models. VIDEO VERSION CAN BE SEEN AT THE LINK BELOW Additional Wire ...

    • How do I install EDM Expert with Turbo Tech

      Installation of EDM Expert -------------------------------------------------------------------------------------- Note: You must have Administrator Rights to perform the actions for the following steps. Note: If you have recently purchased a new ...

    • Knowledge Base Database Dialog Instructions

      The goal of this KB is to explain how the dialog works and its functions. We will start in the Upper Left Corner set of Buttons The button is used to load in the knowledge-based file once selected. The button allows you to cancel the command and go ...

    • Transferring ACvision User Qualities list and Wire list from a previous version to PEPS V2023

      1. Find the list you are wanting to transfer to the new version. Most of the files are found in your data folder. C:\Users\Public\Documents\OPTICAM_ClassicV8.2\Data\wire\ACvision\data 2. Copy the "xxxx.lst" file. 3. Replace the "xxx.lst" file in the ...